BMW Standard Tools is a group of software distributed by BMW Group that contains several interoperating applications and drivers, including NCS Expert, WinKFP, NFS, Tool32 etc.Range Rover I-BUS NBT retrofit adapter.Spent a bit of time honking around with this, so wanted to post my experience so hopefully others can avoid some of my gotchas. BMS / JB4 Meth Install w/BM3 Hey everyone, I finally got my JB4 working with my BMS WMI and Bootmod3 Stage 2 OTS map.Our baseline on the PS2's was 706whp and 905wnm. We did a reference dyno on our F80 M3 with the good old PS2 High Flows on E85 and dual cm5 meth before installing the PS2+. Hi Guys, 2 weeks ago we received a set of PS2+ turbos from our brothers at Pure USA.Below is the information on how to do this for several popular BMW TMAPs we have. Using the Factory BMW T/MAP Sensors with the CM5-LTS In most BMW applications with a CM5-LTS WMI controller, it is preferred to obtain boost readings by 'teeing' into the factory TMAP sensor wiring.learn more BMW Group posts solid third-quarter sales growth. BMW Group confirms outlook for 2020 – significantly improved performance in third quarter.As many of you may have heard, we have been working with Torqbyte on developing of a fully integrated PT-CAN -based LPFP control module for performance-minded owners that prefer doing things the right way rather than entrusting their car’s fueling to other less technologically advanced solutions on the market.Hope this helps anyone and now everything works perfectly. > The fix was to go into Network Settings, select the USB Loopback which has been renamed ' Ethernet 2' and rename it to 'USB' then go into its settings just like you would for an ENET lead and set the IPV4 IP to 169.254.0.8 with a mask of 255.255.0.0 The bit you need to know is that on my laptop and possibly others the USB Loopback network connection was messed up during the Windows 10 upgrade and the Network Config Tool didn't seem to work properly either. However I did eventually figure it out and now ISTA-P runs nicely too, and with the excellent Loader V4.3. Loader V3.2 and ISTA-P was a bit more tricky. I also had Rheingold Standalone 3.47.3 running perfectly with K+DCAN USB and ENET cable.Īfter the Windows 10 update (which failed the first two attempts because it turned out the laptop BIOS needed an update first) most applications were fine.īy simply revisiting the COM port settings for my USB K+DCAN to set back to COM9, minimum buffer sizes and minimum latency Rheingold ran perfectly. I did have ISTA-P (3.54.3) running nicely on Windows 8.1 64-bit with a K+DCAN USB lead (never tried ENET but I think it would have been fine). This might be helpful to those who use K+DCAN USB and ENET interface and do diagnosis and programming with ISTA-D, ISTA-P, or E-sys Windows 10 Home 64-bit.

K dcan driver windows 10